Before planning to solve home electrical problems independently, give good consideration to whether it is absolutely essential, if it is please call your local Los Angeles electricians. Pay attention to safety procedures because electrical shocks can be dangerous. Keep reliable test instruments such as a proximity test pencil, test lamp, and multimeter, to help to check whether the power is on or off on the electrical circuit that is being repaired. Make sure that your test instruments are working properly. Then, turn off the power and ensure that nobody turns the power on while the electrical work is in progress. Home electrical problems are usually caused by faulty connections or inferior materials. There are some common home electrical problems that can be undertaken with proper care.
How Can I Avoid Home Electrical Problems?
1. Nonmetallic Sheathed Wiring (NM Wiring)
Support the NM wiring to the wooden studs by nailing wire straps securely around the wire. These straps usually have two small nails and a wire cover made of plastic to ensure that the wires do not hang loosely.
2. Circuit Breakers
If the GFIs and breakers trip, try and find out what caused them to do so. They could trip due to many reasons.
- They could be wired incorrectly or it could be the fault of something plugged into them or to one of their outlets.
- There could be a poor connection point in or at the breaker itself.
- The circuit can be partially incapacitated due to a poor connection.
One way to avoid home electrical problems is not to overload light fixtures and extension cords. This could heat up some components.
4. Wire Size
While adding an outlet or a circuit, use wires and devices designed for that particular amperage.
5. Fuse Replacement
Another way to avoid electrical problem is to never replace fuses or breakers with wires of higher amperage. This causes overheating of the wire, which can lead to a fire.
6. Correct Wire Length
It is important to use about 6 inches of wire inside the junction box so that there is enough for making connections properly; however, ensure that the wire is not too long or this can cause home electrical problems.
7. Loose Connections
Keep the breaker and neutral connections firm. If the neutral is loose, the lights will flicker or will dim. If the breaker connection is loose, it will cause the circuit to heat up, and, in turn, trip the breaker.
8. Bulb Wattage
Most incandescent light bases carry a wattage limit warning. Do not use a light bulb with a higher wattage than what is advised in the holder. As a higher watt bulb uses more energy, the base will get overheated and might start a fire.
9. Connecting to the Right Terminals
Making wrong terminal connections will cause problems. The hot wire should be connected to the brass-colored screw of the outlet. The neutral wire should be connected to the silver terminal and the ground wire to the green screw.
10. High Electricity Bill
Usual faults associated with electrical wiring will not cause an increase in electric power bills normally. Find out whether your usage is high. The power company may be willing to check and replace the meter. To possibly lower your electric bill and to go green by helping our planet, please call Electricians Los Angeles.
For a free estimate, please call Electricians Los Angeles to schedule an appointment today!